home Dogs What is better to put the dog in the booth

What is better to put the dog in the booth

How to insulate a booth for a dog. How to insulate a booth for a dog for the winter: is it necessary, what to lay and what is the best way to warm it with your own hands

Electric heating

They are used when the possibilities of insulating materials have been exhausted. They are used instead of warming when they consider it impractical, if you need a quick result during a cold snap.

To apply heating, an electric line is supplied to the booth, a waterproof outlet is installed.

Important! The laying of an electric cable throughout the territory is carried out secretly in pipes made of low-pressure polyethylene or in metal pipes with a wall thickness of more than 2 mm.

All commercially available heaters operate in the infrared range, which is beneficial for the animal. They do not create excessive heating, consume a small amount of electricity, are silent, do not burn oxygen, and are reliable in service.

It is produced in the form of a heating plate 2 cm thick. Heating temperature. up to 50 ° С. Fastened with ordinary self-tapping screws, the installation site is a wall. Has a temperature controller. For belay, a protective metal mesh is installed on top.

It is produced in the form of a heating roll, heating temperature. up to 60 ° С. The radiation does not harm the dog, as it corresponds to the natural radiation of the body. It is mounted inside the wall of a doghouse on a backing of a reflective screen and a layer of mineral wool. Necessarily covered with inner lining.

better, booth

Represents the most modern type of heater. It is designed as a hanging rug 50 cm wide and can be up to several meters long. It is hung on the wall of a dog’s dwelling, protected from mechanical damage by a lattice. Simple structurally, durable during operation, harmless to pet’s health.

Installed under floor boards. The heating element is made in the form of a thin plastic plate. It is completed with a thermostat, a temperature sensor. Protected from moisture ingress with a film. Heats the floorboards within 40 ° C without overheating and harming the pet’s health.

They can differ in design, principle of operation. Should not create a risk of fire, electric shock, overheating of the animal. Must comply with the rules for electrical installations.

Should a dog insulate a booth?

But first, let’s look at another frequently asked question.

READ  What food is better to feed the Yorkshire Terrier

Travis Scott. SICKO MODE ft. Drake

Mineral wool

Of all modern insulation materials, fiber mats, panels and roll materials are categorically not recommended to be used to insulate a dog kennel. There are many reasons for this limitation, for example, phenol-formaldehyde resin used in the manufacture of mineral wool, as well as stone dust, from which there is no escape, cause severe irritation of the mucous membranes of the eyes and larynx.

Minwata emits a lot of dust, you need to think ten times before trying to insulate the dog’s kennel in this way

You can, of course, build and insulate the kennel according to the method shown in

It is unlikely that the Alabai, for which the booth was built, will feel comfortable in winter. If you arrange a kennel and try to insulate it according to science, then it is better on the basis of expanded polystyrene.

How and what to insulate a dog’s kennel for the winter with your own hands photo

With the arrival of frost and windy weather, as always, the afterthought comes to insulate the dog’s kennel for the winter. This must be done quickly enough and at the same time with high quality, since many breeds simply do not tolerate severe cold and discomfort. In addition, not all modern materials can be used as insulation for a doghouse.

The choice of insulation for the dog booth

The selection of a method of material for insulating a kennel is faced with two big problems. First of all, the insulation should be relatively harmless, not cause allergic reactions and aggression on the part of the dog. Secondly, the material should not absorb moisture and lose its heat-insulating qualities over time.

Insulation of a dog booth: requirements for thermal insulation. Click!

In anticipation of cold weather, every dog ​​owner thinks about whether the pet needs additional protection in winter, how to create ideal conditions for wintering and whether the dog needs it.

Mineral wool insulation

Do-it-yourself insulation of a booth with mineral wool is a more laborious process than the previous option. However, in theory, it should provide higher thermal insulation if done correctly.

Step-by-step instruction

  • First, the roof is removed from the booth, and its walls are closed with a vapor barrier, which is attached with a stapler.
  • Further, a crate of beams is stuffed onto all the walls.
  • With a knife, “rugs” of cotton wool are cut to the size of the crate and put into it.
  • Then the cotton wool is again covered with a layer of vapor barrier.
  • All this “sandwich” is tightly sheathed on top with wood, plywood, chipboard or OSB so that the dog cannot break the insulation structure.
READ  What food for neutered cats is better to choose

As a result, the walls insulated with mineral wool are quite thick. By a similar principle, you can make insulation and foam. A rug on the floor will make your home more comfortable.


The device, which is intended for heating a dog kennel, has a small size and is designed in a metal case. Installation is simple. The maximum temperature limit is 50 degrees. You can install the heater on the roof or walls of the booth. The positive characteristics of the device are its quiet operation, minimal energy consumption, no need for maintenance, it does not consume oxygen during operation.

A panel heater for a doghouse can be made by yourself

There is an alternative

Many people cannot decide for a long time how and with what to insulate the dog booth for the winter. Should you even protect the kennel from the cold yourself? After all, such insulation does not always guarantee optimal conditions for the pet and requires certain knowledge from the owner. In the cold season, it is better to keep the dog at home or buy her a ready-made kennel, which is designed for very low temperatures.

Such booths have a well-thought-out design and are made with the use of modern insulating materials. This type of kennel will bring comfort to the dog on the coldest days.

Insulation of the kennel with polyurethane foam

This material does not pose a danger to human and pet health, it is resistant to moisture. It is one of the best thermal insulation products. Differs in affordable cost. It is attached to the inside of the booth. Usually elastic polyurethane foam is used. This is due to the openness of its structure and increased moisture absorption. Therefore, it is not used externally.

Polyurethane foam with a rigid structure is suitable for fastening from the outside of the kennel. Basically, this is the best solution when protecting a doghouse from the cold. The material is not toxic, since it is based on plastic. It can be purchased in both liquid and solid form. The liquid material is applied by spraying, and the solid material is in the form of plates.

The slabs are large and not suitable for insulating a doghouse. We advise you to resort to using a liquid form, the main advantages of which include:

READ  How Much Activated Charcoal Can You Give Your Dog

Bride of Chucky (4/7) Movie CLIP. That is a Rude Doll (1998) HD

  • filling all cracks and gaps;
  • protection of the kennel from mold and decay;
  • providing isolation from noise;
  • long service life (over 30 years).

Advantages of electric heating kennel

This type of insulation has many positive aspects:

  • On frosty days, an electric heater will create optimal conditions for a four-legged friend.
  • The kennel will be dry to prevent mold growth.
  • The humid air exhaled by the dog will not turn into condensation and will not settle with frost on the walls of the booth.
  • The heater does not consume a lot of electricity. only 100 W / m².

Insulating materials

Chips, polystyrene foam, felt or mineral wool are used as insulating materials.

Each of these materials has its own characteristics. Wood shavings are difficult to fix on walls and ceilings, but they make a good litter for a dog in a kennel for the winter, soft and environmentally friendly. It should be remembered that parasites often start in shavings, and if moisture gets in, they can completely rot. It is better to add shavings of coniferous trees, the smell of which does not like insects.

The litter will have to be replaced regularly, but it is still better than the fabric one that the dog can gnaw or pull out of the kennel. But sawdust is something that should not be placed in a dog’s booth in winter, since they clog up the nose and climb into the eyes, causing inflammation. The thorny dust prevents the dog from lying down properly in the booth.

Hay is the easiest way to lay a dog in a kennel for the winter. The heap of hay on the floor is easy to replace, and this will have to be done about once a week as hay is also susceptible to rotting. It has a pleasant smell, you can also add dried herbs that scare off parasites. thyme, sage or wormwood. From time to time, the bedding of straw or hay is shaken up so that it does not cake.

If the kennel has double board walls, then shavings or straw are poured into the gaps between them. If the question arises of how to insulate a dog booth for the winter, and then return to the summer version, then this is a suitable solution. But in this case, fleas can overwinter with the dog.

do-it-yourself warm kennel for a dog